150 m3/day to 1650 m3/day

Reverse Osmosis is the membrane filtration process applied to waters where classical purification systems are insufficient (seawater, water with high conductivity, well water, etc.), which separates all undesirable minerals from the water and aims to obtain pure water. Osmosis is a natural phenomenon and, in short, it is the movement of water from a less dense environment to a more dense environment. This process continues until osmotic balance is achieved. Reverse osmosis is the reversal of this osmotic flow. Aqualine Reverse Osmosis Systems successfully provide pure water as a result of this process. Aqualine Reverse Osmosis Systems can be produced in different designs and shapes according to customer requests.

Membrane cases FRP
TFC Spiral wound membranes 8" diameter
AISI304 or AISI316 quality stainless steel vertical centrifugal high pressure pump
ST-37 Epoxy painted carbon steel or AISI304 Stainless steel chassis
Cartridge filter with 5 micron precision
Low pressure line U-PVC PN16
High pressure line AISI304 Stainless steel
Butterfly valve with inlet electric actuator
Pressure adjustment globe valves at the pump outlet and waste water line
Low and high pressure switch
Product water and wastewater flow meters
Glycerin manometers
Product water water conductivity indicator (0-2000µS/cm)
Product water pH meter (optional)
Autoflush, automatic rinse and chemical wash System
On-Off switch
PLC and operator panel
380V/50Hz/3ph
IP56 control board

Recommended Inlet Water Limits

Inlet water TDS: 0 - 2,000 ppm
Working pressure: 10 to 15 bar
Inlet water pressure: 2 to 5 bar
If hardness is more than 3 French, ASC dosage is required
pH range: 6 - 8
Silica (SiO2) Tolerance: 25 ppm max. @ 60% efficiency
Max. Inlet water temperature = 30º C Max.
Max Iron (Fe) tolerance: 0.05 ppm, 0.2 ppm if ASC is dosed
There should be no Hydrogen Sulfide.
There should be no blurriness