AQUALINE MEMBRANE WASHING SYSTEMS

As a result of calcium, fungus, polymers, silica, sand and pollutants formed on the membranes blocking the pores on the membrane surfaces, the membranes cannot function fully. For this reason, Aqualine membrane washing systems are used to open the membranes and allow water to pass through again and perform the purification process.

Aqualine Membrane washing system is designed to be controlled manually via the panel on the chassis. The chemical storage tank is mounted on the chassis. It is connected with PVC pipe and fittings. Before shipment, all cabling and piping is completed in our factory, tested and shipped.

STANDARD FEATURES

SS316 Washing pump
Working pressure 3 bar
380V/3Ph/50Hz
SS304 body Filter with 5 micron PP cartridge
PP chemical solution tank with lid
Lower Level meter switch
PVC piping SCH 80 and Ball valves
Inline flowmeters and Manometers
All equipment is on SS304 chassis.
OPTIONAL FEATURES

pH Controller
electric heater
temperature controller
Chassis movement wheels
mixer
MEMBRANE WASHING CHEMICALS

The most common chemicals used for membrane cleaning are Acid and Alkali based. Acidic cleaners are used to remove iron and inorganic residues and should be done at a pH of approximately 2-3. Alkaline cleaners are used to remove biological materials, organic and silica residues and should be done at a pH of approximately 10-11.

MEMBRANE WASHING PROCEDOR

You may experience a decrease in performance due to the accumulation of residues on the surface of Reverse Osmosis membranes. Mineral precipitation, colloidal particles, biological matter and insoluble organic compounds are the usual causes of membrane fouling. If the production capacity decreases by 15% or the differential pressure increases by 15% under normal operating conditions, membrane washing should be performed. For more information, see the operating instructions.